Special Client-Specific Thread Gauges and Inspection Machine Mountings

GO/NOT GO thread plug gauge and GO thread ring gauge for customer-specific 3-starts special thread.

Multiple GO thread plug gauge and GO thread ring gauge M 12.5 x 6 P 0.75 - 6g (8-starts). Maximum quality with ground thread.

GO/NOT GO thread plug gauge and GO thread ring gauge for customer-specific asymmetric special thread.

The coordinate gauge rod determines the position of an internal thread via a 3D measuring machine. The thread is lightly tapered for centric mounting. Standard version with pitch delay see pages 248 and 293.

GO/NOT GO thread plug gauge with increased stem diameter for checking small, deep seated threads.

Thread ring gauge for mounting in inspection equipment to check radial and axial run-out. The thread of the gauge is lightly tapered to facilitate centring of the workpiece.

HSS TiCN coated GO thread plug gauge with dirt collecting groove for mechanised inspection.

GO thread ring gauge with DLC coating provides outstanding wear.

GO thread plug gauge for checking the thread and coaxiality of three diameters to a thread. The rearward edge shows the minimum length of engagement.

GO/NOT GO thread plug gauge for customer-specific, asymmetric special thread. This thread cannot be measured conventionally due to its very flat thread profile.

Gauge for checking the minimum bore diameter and concentricity of the bore with an internal thread.

Tapered GO/NOT GO thread plug gauge for checking the thread and coaxiality of fit to the thread.

Tapered thread plug gauge to check the taper thread ring gauge for acceptance and wear.